No announcement yet.

Dead-on accurate!

  • Filter
  • Time
  • Show
Clear All
new posts

  • Dead-on accurate!

    I just took delivery of the Ready2Rout system late last week - getting it set up in my table saw extension table (replacing an Incra router fence). I put in a PC7518 router, got everything set up, used the plate to zero out the 3/8" straight bit and ran a quick test cut. Measured by a digital caliper, absolutely dead-on accurate. I'm totally impressed! Now to make some aux fences out of some phenolic-faced 3/4" baltic birch plywood, install some Kreg stops with measuring tape, and off to the races. The supplied fence is fine, but I find the opening for the router bit too big for many smaller jobs. I like to have either a sliding fence (like the Incra) or aux fences that I can close the gap with. Thanks, Matt in tech support, for your support!