Announcement

Collapse
No announcement yet.

Not starting job

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Not starting job

    In my last post (Virtual Zero) when I went back down to the machine everything worked fine up to the point where you actually are ready to cut wood. I picked the .tap file to run and the right file came up on the controller, then I clicked on start and it started to count down the lines of code but the system didn't respond at all. After a couple of minutes at about line 100 I stopped the machine. Tried it again with the same results.
    Starts
    06-13-2022
    Ends
    06-13-2022
    Location
    Lacey, Washington
Working...
X