Announcement

Collapse
No announcement yet.

Shark 5 XY Position

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Shark 5 XY Position

    The XY position shifts about a an inch to the Y away and X right position on my material such that the bit travels off the job material. Job setup is Single Sided, Z is material surface, and I have tried two different corners for XY Datum.

  • #2
    Check to see if you have an offset set in your job setup under "XY datum position". There's a checkbox labeled "Use Offset", make sure that's unchecked.
    .

    Comment

    Working...
    X