Announcement

Collapse
No announcement yet.

Not going back to starting place when using virtual Zero and the touch plate

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Not going back to starting place when using virtual Zero and the touch plate

    Hi, I’m using Aspire 9.5 with a CNC Shark HD2 Extended bed, and trying to use the touch plate with the virtual button in the control panel. It will go to the first position ok then the second one is about an inch and a half short in the (X) axis, then it goes to the third position straight down from the second.Then to the forth position ok and when it comes back to the starting place it to is about an inch and a half to the left of the starting place in the (X) axis. It was working good don’t know what happened. I’ve had to replace the X axis chip in the control box before I hope that isn’t the case again. Can someone tell me what is going on? I tried to can Vectric but closed on the weekend. Thanks Tim
Working...
X