If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
My work table does not line up with X and Y axis. I would have thought I could have used T square off side of table to square up work. Seems the linear shafts and table are not true with each other.
Tim
One way to line it up is to machine a spoil board to fit your project. Another is to run your router with a bit down the side of the project (while it's off) and line it up that way. I'm assuming you have a Piranha?
Comment