No announcement yet.

Jig for M & T joints

  • Filter
  • Time
  • Show
Clear All
new posts

  • Jig for M & T joints

    A jig I built to use with the R2R fence and lift to make slots for loose M & T joints. It moves horizontally on a set of drawer slides and the clamping block can be orientated for cuts in both horizontal and vertical members . I also added a 45 degree clamping block to cut slots in mitered joints.

  • #2
    Just seeing this - cool! Are you attaching it to the fence? I'm having difficulty sorting out how it would work.


    • #3
      Yes it is attached to an auxiliary fence.Thought I had posted more pictures but can't locate them now. if you need more info contact me. One note when plunging into hard woods like oak if using the ready to lift, do so in small steps or you will cause the lift to over load and slip thus loosing your height setting