Announcement

Collapse
No announcement yet.

Z axis not perpendicular to the table

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Z axis not perpendicular to the table

    I was surfacing my spoil board and noticed ridges when the tool was running side to side. It appears that the spindle isn't perpendicular to the table. I can't find any adjustment features to align the spindle. It is probably obvious that I'm new to this but I think it is important for everything to be as perfect as possible. Has anyone else experienced this? Any ideas or suggestions?



  • #2
    I have an HD4 with the extended bed. Today I was going to remove the bolts that tighten the spindle and use a square to check the alignment. It was a tight fit installing the brackets for the spindle and maybe I misaligned them when I set it up.

    Comment

    Working...
    X